Home/Roof Repairs/Colorbond & Metal Roof Restoration in Lennox Head, Ballina & Byron Bay
Cleaning a metal roof with a surface cleaner on the Northern Rivers

Colorbond & Metal Roof Restoration in Lennox Head, Ballina & Byron Bay

A Colorbond or metal roof restoration brings a faded, chalky or rust-spotted metal roof back to a sound, coated finish. We soft wash it at low pressure, replace failed screws with Class 4 coastal screws, treat and prime rust, seal flashings, then apply a metal primer and two coats of roof membrane. On the Northern Rivers it starts from $4,000 for an average single-storey home, confirmed after a free inspection. If the roof is young and only the screws have failed, a re-screw is the whole job and we'll tell you that instead.

Why this matters on the Northern Rivers coast

Metal roofs near the ocean wear from the fixings out. The rubber washers under the screws perish in the sun, salt gets into the screw heads, and rust starts around them and at the sheet laps where salty water sits. The paint on the sheets fades and chalks on the sunny slopes long before the steel itself is in trouble.

A lot of that salt sits where rain never reaches: under the eaves, on gutter undersides and at overlaps. BlueScope's maintenance guidance asks coastal owners to wash those sheltered areas regularly for exactly that reason. On a restoration we treat those spots first, because a coating applied over salt and early rust at the laps is where metal roof coatings fail first.

Signs you need this

  • Rusty screw heads in neat lines across the roof
  • Rust stains spreading down from screws or along sheet laps
  • A chalky residue when you wipe the sheets
  • Faded, patchy colour, usually worst on the north and west slopes
  • Loose or squeaking sheets in strong wind
  • Older galvanised iron going dull grey with rust spots

What we do, step by step

  1. 1

    Inspection of every screw line, lap, flashing and gutter, photographed and itemised.

  2. 2

    Low-pressure soft wash with a roof-safe cleaner, then a fresh-water rinse to remove salt.

  3. 3

    Failed screws replaced with Class 4 (AS 3566) screws; loose sheets re-fixed.

  4. 4

    Rust spots wire-brushed, treated and spot-primed; rusted-through sheets quoted for replacement.

  5. 5

    Flashings and laps sealed where needed; gutters and valleys cleared.

  6. 6

    Metal primer, then two topcoats of roof membrane, with a before-and-after photo report.

What's included

  • Photographed screw, lap and flashing inspection
  • Low-pressure soft wash and salt rinse
  • Replacement of failed screws with Class 4 coastal screws
  • Rust treatment and spot priming
  • Primer for metal plus two membrane topcoats
  • Gutter and valley clear-out
  • Before-and-after photos and a written workmanship warranty

Materials we use — and why they suit coastal homes

Every replacement screw is Class 4 to AS 3566, the class rated for severe coastal exposure, with a new sealing washer. Rust is treated and primed before the main coats so it doesn't keep spreading underneath the new paint. The primer is a metal primer matched to Colorbond, Zincalume or galvanised steel, and for beachfront homes we can step up to a primer with stronger corrosion resistance, as BlueScope's TB-2 bulletin suggests for severe marine sites. Topcoats are a flexible acrylic roof membrane, the paint type TB-2 describes as generally the most suitable for overpainting this steel.

Should you paint a Colorbond roof at all?

Colorbond's factory finish is designed to last a long time without paint, so while the colour is still in good shape the right job is usually maintenance: a soft wash, a check of the screws, and rinsing the sheltered areas with fresh water. COLORBOND steel's own advice is to hose those unwashed areas at least twice a year, and more often on the coast. Painting a roof like that early buys you nothing and costs you the BlueScope warranty.

Painting starts to make sense when the factory colour has faded or chalked badly, you want a different colour, or the roof is an older Zincalume or galvanised roof that never had a colour finish to begin with. At that point a properly prepared coating adds protection on top of the steel's own metallic coating and makes the roof look new from the street.

If you're not sure where your roof sits, the guide on whether roof painting is worth it in Byron Bay and Ballina (linked below) goes through the warranty question in more detail.

Old iron roofs on hinterland homes

Up in Bangalow, Alstonville, Wollongbar and around Lismore there are plenty of older timber homes with galvanised corrugated iron roofs. These have less salt to deal with than beachfront roofs, but more rain, leaf litter and age. Typically we find rust at the laps and under overhanging trees, nail or screw fixings that have worked loose, and gutters full of leaves holding water against the sheets.

If the iron is sound, these roofs restore well. Rust is treated and primed, fixings are replaced with screws, and the roof is coated in a colour that suits the house. Where a heritage conservation area applies, such as parts of Bangalow, check colour and consent with council first.

How much does it cost?

Colorbond and metal roof restoration from $4,000 for an average single-storey home, confirmed after a free on-site inspection

If the sheets are in good shape and the problem is rusty or leaking screws, a metal roof re-screw from $2,000 is often the whole fix. Spot rust on its own starts from $400 through our rust treatment service. A full restoration makes sense when the screws, rust and faded paint all need attention at once. Further reading: is roof painting worth it? and painting a roof in Bangalow's heritage area.

Repair, restore or replace?

Restore a metal roof when the sheets are structurally sound and the issues are screws, surface rust and faded paint. Replace sheets when rust has eaten through them, when laps are rusting apart, or when the roof has been patched repeatedly. A young Colorbond roof under warranty is usually better off with a wash, a re-screw where needed and regular maintenance than with paint, because painting it voids the BlueScope warranty.

Get a quick quote for this job

Free, no-obligation quote

A few details and we'll call you back with a price — no obligation.

By submitting you agree to be contacted about your request.

Frequently asked questions

Our Colorbond and metal roof restoration starts from $4,000 for an average single-storey home, confirmed after a free inspection. It covers the soft wash, screw replacement, rust treatment, a metal primer and two membrane coats. Rusted-through sheets, new flashings and solar panel removal are quoted separately.